For a BB5 (Barrel type) is it possible to have a side suction and side discharge nozzles instead of a top suction top discharge.If possible are there any limitations or concerns that needs to be taken

At the attachment is a image of a hand operated vacuum pump named "Komovskiy vacuum pump" , do any member ever see or use this kind of pum?I want to know what is the max vacuum it can achieve.Thanks i

These devices buffer any pressure wave fronts coming to the sensor but will not alter your system. Just unscrew the transducer, screw one of these in, and screw the transducer back in. Make sure you

"For your application, restricting the discharge side of the pump will have negligible effect on the suction side."Just so I'm clear then,The Dole Valve will be installed after the flow meter on the d

For a properly designed system, relief from a centrifugal pump is caused by the pump circuit being blocked-in. The pump head rises along the curve. The actual pressure at the pump discharge will be th

I agree that the major wear is at cold startup...intuitive.I disagree that this "wear" is excessive in most street applications. It is not at all uncommon to have modern engines make 400,000 miles an

jistre, the proposed pump curves prior to rebuild showed head rising to shut off, but the FAT curves did not demonstrate the same phenomenon. The pumps have been purchased, therefore, starting over w

OK. But just remember its comparing apples to oranges and you usually get what you pay for... or don't.For lo press, lo temp, non-critical services, non-hazardous substances, lo stress conditons, I d